Ashly NE Series 4250 Four-channel 250W ch at 4 Ohms Amplifier- 70V DSP

Ashly NE Series 4250 Four-channel 250W ch at 4 Ohms Amplifier- 70V DSP

  • $2,430.00
    Unit price per 

Ashly NE Series 4250 Four-channel, 250W/ch at 4 Ohms Amplifier- 25V, 70V, 100V

Connecting and controlling an amplifier for networked systems has now been simplified with Ashly's NE Series amplifiers. Network Enabled (NE) amplifiersoffer ease of use, setup and control using standard 10/100 Ethernet protocoland Protea NE Software. No special outboard control units are needed.

Four-channel models with output power at 250W are available to fill a wide variety of low impedance, 25V, 70V and 100V performance installation or constant voltage applications. NE Series amplifiers are offered two ways; standard input with euroblock connectors and "pe" (Protea Enabled) with euroblock input connectors and world renowned Protea DSP signal processing.

The DSP signal processing library is extensive and utilizes two SHARC 32-bit/96kHz processors. Processing blocks include Graphic, Parametric, Notch and Shelving Equalization, High-, Low- and All-Pass Filters (HPF/LPF/APF) with up to 48dB/Octave slopes, Delay, Compressor/Limiter, Gate, Ducking, Auto-leveler, Gain and Signal Generators (sinewave, white and pink noise). A full Matrix Mixer with assignable routing allows any input to drive any or all amplifier outputs.Presets can be used to store and retrieve global parameters of an entire amplifier's control surface and DSP section.

Additionally, each amplifier also provides DC voltage control of the attenuatorswhich makes it a snap to control volume from remote locations, preset recall, Remote Power Standby and data in and out ports for connecting accessories like the WR-5 to control user selected parameters. There are LED indicators for power, standby, protect, network communications and each channel has a four-step signal meter, bridge mono, temperature and current indicators.


  • Four Channel Amplifier
  • Ethernet control Is standard
  • Low-Z, 25V, 70V and 100V Models
  • Extensive DSP Available
  • Easy and intuitive user interface
  • Extensive protection circuitry
  • Safety/Compliance: cTUVus/FCC, CE (pending), RoHS

Front panel:
  • Level attenuators for each channel
  • Power switch can be disabled by software
  • 4-Step Signal Level and Clip LEDs

Rear panel:
  • 10/100 Ethernet port
  • Euroblock inputs
  • Euroblock outputs
  • Remote level control
  • Preset recall
  • Remote power turn-on/off
  • Data in and out ports

We Also Recommend